2012 RAM Pickup

//2012 RAM Pickup

2012 RAM Pickup

RAM Pickup

Mileage
120,943
Service Date
6/30/2021
Services Performed
  • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
  • CHECK BRAKES, TIRES, CHECK VEHICLE FOR OIL LEAKS, SUSPENSION, DRIVELINE AND FLUID LEVELS.
  • MILEAGE MAINTENANCE @120,000 MILES – 3500,4WD,Diesel,Automatic Trans – w/Single Rear Wheels
  • FUEL FILTER – Remove & Replace – 3500,In-Line6 Element
  • Road test and verify engine performance, transmission operation, and shift patterns. Flush transmission which includes: flushing of transmission cooler, cooler lines, valve body, and torque converter. Flush all contaminated fluid out and replace with new fluid as per vehicle specs.
  • BALL JOINT – Remove & Replace – 3500,4WD w/Single Rear Wheels,Both Sides,All Four – [Includes: R&I Steering Knuckles.] – [DOES NOT include alignment.]
  • DRAG LINK – Remove & Replace – 2500,3500,Recirculating Ball Type Gears – [DOES NOT include alignment.]
  • TIE ROD &/OR END – Remove & Replace – Rack & Pinion Type Gears Inner,Both Sides – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion
  • TIE ROD &/OR END – Remove & Replace – Rack & Pinion Type Gears Outer,Both Sides – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Ti
  • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – 3500,4WD,Diesel Both Sides – [DOES NOT include alignment.]
  • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both Sides – [DOES NOT include disassemble or alignment (where applicable).]
  • BRAKE SHOES &/OR PADS – Remove & Replace – 3500 Front – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
  • PINION SHAFT SEAL – Remove & Replace – [Includes: R&I Drive Axle.]
 
ERIC Z. gave our service a 5 star review on 7/1/2021
2021-07-02T22:02:02+00:00